11/16/2023 0 Comments Cold cathode lights![]() After that, add a female power connector so that you can plug in and unplug your power supply. Once you've gotten the cold cathode light to work, simply solder on a power switch in between the power inverter's inputs and the power supply's output. If however you connected something the wrong way, you will see some smoke come out of your power inverter and that will mark the end of its life. If you did everything right, the cold cathode light should light up. Once you have figured out all of your polarities, simply hold the input wires of the power inverter onto the correct sides of the power supply connector. It will tell you whether the outside and inside of your power connector are positive or negative. There should be a small diagram that you can see in the top right of the second picture in the slide show. The black one is ground (negative -) and the other colored one (often red) is the positive input (+).Ģ)After you have determined the polarities of the input terminals to the inverter, look at your power supply (the one that plugs into the wall). To see which way you need to connect your wires follow these instructions:ġ) Look that the colors of your stripped wires. Note that ifyou connect the leads the wrong way, you will destroy your power inverter and you won't be able to continue. After that, I stripped the input leads to the inverter, connected the scanner's original power supply to the wall, and used the stripped leads to test the lamp. Next, I extracted the cold cathode lamp and its power inverter (a small circuit board with a transformer and some capacitors and coils). This is probably the only part that you will need (unless you decide to reuse some switches and power connectors from the main board of the scanner). Then, I removed the stepper motor and took out the light assembly. By extracting them and wiring up a simple circuit, we can get ourselves a virtually free (Unless you were forced to pay a few dollars for the broken scanner) cold cathode lamp.įirst, I took apart the scanner, and removed all of the circuitry. In most cases, when a scanner breaks, part of its scanning and/or computer connection hardware is damaged, but the cold cathode light and power inverter are often in pristine condition. Scanners use cold cathode lamps to illuminate the images that they are scanning so that a special IC (Integrated Circuit) can scan them. This is a description of how I made a small cold cathode lamp for free.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |